The CT30 is a non-regenerative filter style desiccant air
dryer. The CT30 desiccant air dryer can be used for any
point-of-use application where you want protection from water, oil,
and dirt. The CT30 has a capacity of 30 SCFM.
- Air Inlet ½" NPT (Female)
- Air Outlet ½" NPT (Female)
- Air Flow Capacity 30 CFM
- Maximum Operating Pressure 200 PSIG (14 Bar)
- Maximum Temperature 150˚F (65.6˚C)
- Humidity Indicator Green: OK
- Yellow: Replace Desiccant
- Water Vapor Removal -40˚F Dew point
- Partical Removal .01 micron
- Manual Drain Included
The CT30 comes fully assembled, uses no electricity, and is easy
to install in your existing compressed air line. Install it near
the intended point-of-use.
Typical compressed air is saturated with 50% to 100% relative
humidity. That means that the compressed air is carrying a lot of
moisture vapor when it goes into your paint gun or point-of-use
application. Filters and traps only take out liquid water that has
already fallen out of the compressed air and do nothing to protect
against the 50 to 100% moisture vapor still remaining in the
compressed air.
The CT30 desiccant air dryer removes moisture vapor down to .5%
relative humidity or a -40°F degree dew point. This means no
moisture can condense into liquid water until the compressed air
sees a temperature of -40°F.
The CT30 desiccant air dryer is 100% satisfaction guaranteed. If
for any reason you are not completely satisfied, simply return it
for a full refund. If you have questions on how to properly select
a compressed air dryer, contact our knowledgeable customer service
toll-free: 866-650-1937 or send us an email request.