Details
The CT30 is a non-regenerative filter style desiccant air
dryer. The CT30 desiccant air dryer can be used for any
point-of-use application where you want protection from water, oil,
and dirt. The CT30 has a capacity of 30 SCFM.
- Air Inlet ½" NPT (Female)
- Air Outlet ½" NPT (Female)
- Air Flow Capacity 30 CFM
- Maximum Operating Pressure 200 PSIG (14 Bar)
- Maximum Temperature 150°F (65.6°C)
- Humidity Indicator Green: OK
- Yellow: Replace Desiccant
- Water Vapor Removal -40°F Dew point
- Particle Removal .01 micron
- Manual Drain Included
- Contains Initial Desiccant Cartridge Bag Fill
The CT30 comes fully assembled, uses no electricity, and is easy
to install in your existing compressed air line. Install it near
the intended point-of-use.
Typical compressed air is saturated with 50% to 100% relative
humidity. That means that the compressed air is carrying a lot of
moisture vapor when it goes into your paint gun or point-of-use
application. Filters and traps only take out liquid water that has
already fallen out of the compressed air and do nothing to protect
against the 50 to 100% moisture vapor still remaining in the
compressed air.
The CT30 desiccant air dryer removes moisture vapor down to .5%
relative humidity or a -40°F degree dew point. This means no
moisture can condense into liquid water until the compressed air
sees a temperature of -40°F.
The CT30 desiccant air dryer is 100% satisfaction guaranteed. If
for any reason you are not completely satisfied, simply return it
for a full refund. If you have questions on how to properly select
a compressed air dryer, contact our knowledgeable customer service
toll-free: 866-650-1937 or send us an email request.