The CT30 is a non-regenerative filter style desiccant air dryer. The CT30 desiccant air dryer can be used for any point-of-use application where you want protection from water, oil, and dirt. The CT30 has a capacity of 30 SCFM.
- Air Inlet ½" NPT (Female)
- Air Outlet ½" NPT (Female)
- Air Flow Capacity 30 CFM
- Maximum Operating Pressure 200 PSIG (14 Bar)
- Maximum Temperature 150°F (65.6°C)
- Humidity Indicator Green: OK
- Yellow: Replace Desiccant
- Water Vapor Removal -40°F Dew point
- Particle Removal .01 micron
- Manual Drain Included
- Contains Initial Desiccant Cartridge Bag Fill
The CT30 comes fully assembled, uses no electricity, and is easy to install in your existing compressed air line. Install it near the intended point-of-use.
Typical compressed air is saturated with 50% to 100% relative humidity. That means that the compressed air is carrying a lot of moisture vapor when it goes into your paint gun or point-of-use application. Filters and traps only take out liquid water that has already fallen out of the compressed air and do nothing to protect against the 50 to 100% moisture vapor still remaining in the compressed air.
The CT30 desiccant air dryer removes moisture vapor down to .5% relative humidity or a -40°F degree dew point. This means no moisture can condense into liquid water until the compressed air sees a temperature of -40°F.
The CT30 desiccant air dryer is 100% satisfaction guaranteed. If for any reason you are not completely satisfied, simply return it for a full refund. If you have questions on how to properly select a compressed air dryer, contact our knowledgeable customer service toll-free: 866-650-1937 or send us an email request.